Products Support > GSX Support MSFS

AFCAD File for add-on airport "LOWW" from Gaya Simulations

(1/3) > >>

Hanse:
I have the "gaya-simulations-airport-loww-vienna" installed in my MSFS Community folder. I can load GSX at this airport but when I try to modify the position the basic AFCAD file is used and not the one from the community folder. I followed the advice in another thread and also copied the bgl files
- Loww-scene - static.bgl (910 KB)
- modelLib.bgl (137,300 KB)
to the folder "C:\Users\MyName\AppData\Roaming\Virtuali\GSX\MSFS" but without any change. Is it maybe the size why GSX does not detect / load this file. Please find the log attached.

Regards,
Rolf

Hanse:
Also adding:
airportCacheOptimizeSearch = 1
airportCacheMaxBGLSizeBytes = 150000000
to the Couatl.ini does not change the behaviour. In the log-file is still stated:
"airportCacheOptimizeSearch enabled, excluding files larger than 4000000 bytes"

AUA9085:
I was able to modify LOWW but its reading the default afcad too on my end.

mseiwald:
same here

Hanse:
After updating I found a new file called "Couatl_MSFS.ini" in the AppData/Roaming/Virtuali folder. After adding the a.m. two lines to the content all files now were scanned including "gaya-simulations-airport-loww-vienna". But still the MSFS AFCAD-files was used in GSX. To me it seems that this is a "Marketplace" version even that I bought it directly from ORBX. If this is the case only Gaya Simulations can solve this problem as mentioned in the GSX Manual.   

Navigation

[0] Message Index

[#] Next page