General Category > Unofficial F/A-18 Acceleration Pack board
Sludge Hornet v2.0
BertAtHome:
Thanks Slugde, I think I've got it right now.
Sent from my GT-I9300 using Tapatalk 2
ctec1:
I've had the structure set up as in the pic below and still cant hear Betty.
So I ran a fire test. I could hear Betty going thru the test but it was very faint and thats @ idle on the runway. During flight with the all the environment and engines sounds I barely can even make her out. So they are working but hardly audible. I'm using P3D and went thru the sound settings to try to increase the volume but havent had any luck just yet. I'm going thru my sound card settings also but so far havent seen a change. It might be something going on in my system but not sure at this point. Any ideas?
Herbie:
--- Quote from: ctec1 on March 10, 2013, 10:39:53 pm ---I've had the structure set up as in the pic below and still cant hear Bett
You are right, The Betty sound are to quiet. I did changed all of mine with a wave-editor. But, Sludge know another way. Herb
--- End quote ---
Herbie:
Hello!
Did somebody notice: flying the approach, the Elevator- Trim changes. My setting won't stay, if a set it to 3, it goes lower or higher. Can't get a glide-slope. I use a wheel on my throttle for the trim set in FSUIPC Module. Herb
Sludge:
CTEC...
You can change the volumes of the individual sounds, but you might wanna check the your in-game FSX volume settings as well. Specifically, change the "voice" option under volumes and see if that doesn't solve your problem. What's the volume if you pull up the ATC window? If you can hear that loud and clear enough, let me know, and I'll look into changing the volumes of the Betty sounds. I'll look into it and see if there's possibly something else keeping the sounds low?
Herbie...
Hmm, did you install the HotFix.ZIP? If so, it should have the PA-PID.XML disabled so your trim inputs stay without any interference.
Later
Sludge
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version