I could be wrong, I often am, but it looks to me like either your gauges didn't install for some reason, your Hornet_FCS.dll is the wrong one, or the .NET Framework wasn't allowed to install.
OR, you didn't accept the gauges when you first ran P3D. I don't have P3D, so I can't say for certain, but I think when you install a new plane, like in FSX, it asks you if you want to allow the gauge to run. You must answer YES to the question when the little box pops up when you first select the new plane to fly.
First thing you should do, IMO, is to go back a couple pages of this thread, to where Jimi posted an updated Hornet_FCS.dll, download it, and install it according to the directions he gives in the same post. I'll see if I can find it for you...
EDIT: I found it. It's on page 99 of this thread, down near the bottom. Or, just follow this link:
http://www.fsdreamteam.com/forum/index.php/topic,6944.msg117227.html#msg117227Hope this helps...
Pat☺
You didn't interrupt the install at any point, did you? Sometimes, during the .NET Framework install, it can LOOK like it's locked up, but it's not. You have to just let it run until it's finished. Can take a few minutes, up to 15 or so.
I hope something in all my babbling helps...
Pat☺