Understood all your comments, except the above. are you saying that there is an AES file for Geneva within the DFGeneva scenery?
I'm saying that, if you have any AES file for Geneva, it can only belong to Dreamfactory LSGG, because there's no AES file for FSDT Geneva yet so, I guess this one should be disabled as well.
However, please take my comments on AES with a grant of salt, because I don't fully know how AES works, this is really a question which doesn't belong to this forum. I don't even have AES installed, and never really tried any of our products with AES. We just trust they work and, in case there might be any problems, it's usually Oliver that contacts us alerting of that.
If so, is this also the case with KORD and KJFK. Because this problem started as soon as I installed KORD may weeks ago.
I'm sorry, but you initially said a very different thing: you said that you just installed Geneva, and it didn't worked, then you installed AES 1.98b, and it suddendly start working again, so it obviously had something to do with AES in some way.
Also, reading your first message again, were you say the scenery worked (after reinstalling AES 1.98b) fine, until the trial period ended. But it's not clear if you have actually *bought* Geneva because if you haven't, that's exactly what is supposed to be happening.
Now, you are saying the problem instead when you installed KORD many weeks ago ? Then why you haven't reported it back then ? And, are you using KORD with AES or not ? I'm a little bit confused.
Anyway, the suggestions are always the usual ones:
- If the Addon Manager appears, it means there are no problem with the software running.
- If the Addon Manager says in the "About" option the scenery is Active, then it's active, no doubt about it, so you would know it's not a registration problem.
- If the Addon Manager doesn't list the scenery as active, it WILL run in Trial mode for a few minutes at a time, it WILL NOT just disappear!
- If the scenery, instead, just disappears at start, it's not a registration problem, it's not an activation problem, it's 100% sure it's ANOTHER scenery in conflict OR a problem in the Scenery Library.
- Another scenery in conflict might be either a duplicate AFCAD OR another scenery with a wrong exclusion area. I'm sorry not being more helpful, but we can't really control what other sceneries out there do.
- A problem with the Scenery Library might be a corrupted scenery.cfg that our installer hasn't touched, because in case of error in the file, the installer will not touch it. You can check this easily: if you go to the Scenery Library and don't see either Geneva, or KORD, or KJFK listed, this was the reason. In this case, you can easily add the sceneries manually, by browsing the Fs9\fsdreamteam folders and add the missing sceneries one by one, the RESTART FS9 to apply the changes.
I think to have covered all possible cases.