General Category > General Discussion

Esellrate question

<< < (2/3) > >>

Hodge001:
Hi

I thought that I should add a little more information regarding my computer set-up.

My internet connection has it’s own Ethernet cable going to a BT Home hub, which is disconnected during FSX sessions (except for product activations such as yours and RG’s LOWS scenery).

My network is connected via it’s own Ethernet cable connected to a separate network card to a network hub, and when the confirm serial number popup appears I only switch off the networked computer, so that I can activate the BT Home Hub and let the main FSX computer connect to the internet, and the serial number confirmation to be carried out, which it appears to do as FSX will then start up.

I then disconnect from the internet, start my network computer and restart FSX, which then brings up the serial number confirmation required popup, and both scenery packages are shown as active in the addon manager (as they always have since I installed them after the rebuild using the backup reg key).

As I hope you understand, that I’m extremely reluctant to let an unsecured networked computer access the internet, and if this is the only solution, then I’m afraid that I will have to forgo using your excellent scenery, and will have to reluctantly remove it from the system.

I hope this information can help.

Thanks for taking the time to assist.

Jim Hodkinson

Hodge001:
Hi

I realise that this may not help with the attempt to discover what is causing the popup serial number confirmation problem, but as FSX will now no longer start under any configuration, and that using the FSX installation disks to perform a repair still will not allow FSX to start, I’m left with no option but to uninstall, reformat the drive and make a fresh installation of FSX,

I appreciate the time and effort that has been put into trying to rectify my esellrate problem, and when the installation is completed I will install both LSZH and KORD on the fresh installation before any other add-ons, and see if this has cleared the problem.

Once again thank you for the assistance.

Jim Hodkinson

Julean:
Hi

Have the same problem.
I have just have the problem that I lost contact with my Pmdg.dll files an needed to reinstall them. Now this library bglmanx problems. I have manually deleted all the bglmanx and Cuatl files. And reinstalled with the newest addonmanager. And right clicked all places and "run as administrator"

All the best

Jens Michlas
DK

virtuali:
That error has been explained many times, it doesn't have anything to do the permissions or esellerate, and it's not a program error, it's an FSX bug, sometimes FSX has problems launching a new module that has been just installed and trusted.

Ignore it, allow it to run anyway, then exit FSX and relaunch it. It usually goes away on the second launch. If not, reboot Windows and try again.

Julean:
Thank you for your reply

I have done what you instructed. Sadly  But when I click "yes" right away: Microsoft Flightsimulator needs to close...

What can I do now then

Thanks

Yours

Jens Michlas
Frederiksberg

DK

Navigation

[0] Message Index

[#] Next page

[*] Previous page