Products Support > GSX Support FSX/P3D
GSX update: what a disaster!
imranrshdkhan:
--- Quote from: virtuali on August 23, 2022, 11:37:44 pm ---
--- Quote from: airbadger on August 23, 2022, 11:22:54 pm ---It does not work. Here's an entire thread with people replying that following your instructions does not fix the issue
--- End quote ---
There isn't an "entire thread", after my last post with more clear and revised instructions, only two replied, one that didn't want to remove the Addon Manager, another saying it doesn't work, without proving extra information.
Proving a log when something doesn't work, is always helpful.
--- End quote ---
Solve this ----> see attachment
FOD:
Tried the new installer twice yesterday - both times with problems including the “coatl not started” error which I had not seen before. Does seem that the current install is not compatible with P3D.
flaviossa:
--- Quote from: FOD on August 24, 2022, 09:41:08 am ---Tried the new installer twice yesterday - both times with problems including the “coatl not started” error which I had not seen before. Does seem that the current install is not compatible with P3D.
--- End quote ---
The process coatl.exe opens ok here (i can see the icon in systray), BUT as soon as i click in "OK" to fly, the process crashes. And there is a crash error message in windows events monitor saying that coatl.exe process crashed but it not says why (at least in my low TI knowledge)
After that, there is no GSX option in "Addons menu", only the "Addon Manager" saying that all my FSDT products are in TRIAL mode (Even if they all were activated ok before this gsx issue)
virtuali:
Assuming you installed the offline installer and nothing else, a crash like that seems to be caused by the antivirus, be sure it's configured to have the whole Addon Manager folder in the Exclusions, then run the offline installer again.
flaviossa:
Thanks Umberto, but my antivirus (Kaspersky) is the same as allways as before. I didnt change anything and it was working perfetly before.
Anyway, i did another try just now to verify and this time i created a exclusion in kaspersky antivirus:
When P3D is opened it appears to be working ok:
As soon as i click in "fly" the coatl.exe process closes:
No GSX options in addon menu, just "addon manager":
The error message in windows event viewer:
This is the file i ran before start the simulator (Ran just this one):
If i run coatl.exe by hand, it shows all my addon in TRIAL mode. If i try to register my products again, this happens:
This situation happened just AFTER the fatidic update. Before, it was working perfeclty (even with antivirus on, etc)
As said before, im not complaining, just trying to add more information. The log is attached below. (I waited in the sim for the time to recreat a new DB as instructions, wich is fast here in my end) But if there is no coatl.exe process running i doubt it was creating anything.
I think ill stop trying correct this for now and wait for a final correction. It´s better.
Thanks and good luck.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version