Products Support > GSX Support FSX/P3D

Unable to edit service vehicles

(1/3) > >>

renzomarcus:
Hi there,

On the latest version it seems that changing the location of ground vehicles is no longer saved when you go to the next gate or when you go out of editing mode. They always spawn back to their default location (Tested on the LPPD scenery available through ORBX). I couldn't see this reported yet and assume a bug at this point, as I did a full clean install of Windows and P3D and had no errors.

Kind regards,
Renzo

virtuali:
Checked it now, they works as usual.

Papacoach:
I can report this at KORD v2 as well trying to edit C9. Selecting customize wouldn't launch the vehicles. It appeared to have some effect as the aircraft changed to slew. I did need to select the Y key to exit.

Will try other airports, gates and aircraft.

virtuali:

--- Quote from: Papacoach on February 17, 2022, 01:56:55 am ---I can report this at KORD v2 as well trying to edit C9. Selecting customize wouldn't launch the vehicles.
--- End quote ---

I tried that exact gate at KORD V2, purposely using the PMDG 737 in order to put more stress on the sim, and it works normally.



Are you doing something different ?

Papacoach:
Good morning. After an update and reboot this morning I no longer have the issues I was facing yesterday. The only other change in the system yesterday was installing the latest active sky, which did run a VC++ redistribution or two.

Problems included calling the ctrl/f12 with no response, the vehicle customization not showing vehicles, and a couatl crash (disappearing from menu) after running the restart/rebuild.

Anyway, all seems good today. Thanks again for your perseverance!

Navigation

[0] Message Index

[#] Next page