Products Support > GSX Support FSX/P3D

GSX installation issue **SOLVED**

<< < (2/3) > >>

Dylan:
Hello again,

I gave up on installing after awhile but I have decided to try again. I have done everything above . After looking at forums I realised I had to install Qw757 before GSX. I have reinstalled everything but still had the problem so I activated couatl error logs. The error log states that bglmanx non ready yet, waiting. How would I go about fixing this? Thank you again.

Dylan

virtuali:
Uninstall the QW757 and be sure you get the latest version.  If you used an old installer, which came with an older version of the Addon Manager that is not supported anymore, will likely conflict with it.

During the Uninstall, if it asks if you want to remove the Addon Manager, SAY YES.

Then, reinstall GSX again and be *absolutely* sure the Addon Manager folder is added to the antivirus Exclusion BEFORE installing it.

Dylan:
Hello, dried the reinstall with qw757. Still does not work. I am going to dry the dependency walker Utility to check for currupted runtike libraries, but is there any other solution. I have followed everything above exactly.

virtuali:
Try to remove all versions ( there might be more than one ) of the VC++ 2005 and 2013 runtime libraries from the Windows Control Panel, then RESTART WINDOWS ( this is important ).

Then, reinstall GSX again, which will reinstall the correct version of the VC++ libraries and RESTART WINDOWS AGAIN, see if it works now.

Dylan:
Yea, still doesn’t work. It worked before I installed the qw757 in, could it be a problem with that? (Even though I reinstalled everything from scratch). Bglmanx trust popup was shown and accepted, however nothing loaded in the addon menu. Couatl.log shows bglmanx was not ready. Dependency Walker said that it was not a valid 32/64 bit windows module. Runtime libraries all installed correctly and addon manager excluded from antivirus. Corrupt bglmanx?

Navigation

[0] Message Index

[#] Next page

[*] Previous page