General Category > Unofficial F/A-18 Acceleration Pack board

Carrier Wake Breakup fix

(1/4) > >>

Voodoo:
If, like me, you've been fed up with the default Carrier wake that keeps breaking up into segments. You might like to try the fix I've attached here.

I have not exhaustively tested this fix but, for me at least, the wake now no longer breaks up into segments. It should work with both the original default carrier and the modified default one (the one that's got the added steam effects).
UPDATE - Javier's carriers fixed too...see next post.

The wake breakup problem also exists with other warships in the AccPack. So...if this fix works for enough people then I will try and do fixes for these other vessels as well.

If you do decide to try it out, I would be very grateful if you could let me know if it does or does not work for you. Full installation instructions are included in the zip.

Cheers all,
Voodoo

Voodoo:
Please find attached, the wake fixes for the Nimitz and the Patuxent.

PLEASE NOTE, if you apply the fix in the first post, you'll have to apply these ones too - or you will lose your Nimitz and Patuxent wakes!

The installation follows on from the instructions in the above post; simply go to the SimObjects/Boats/USNS_PATUXENT folder and replace the sim.cfg file with the corresponding new file provided. Then do the same in the USS_NIMITZ folder with the appropriate sim.cfg file for there.

Again, any problems, please let me know.

Intrepid:
Thanks VooDoo
Like I have said before ,,You keep earning your  ;) spot at the top of my Sim Hero's list ;D
I will give it a try and report back to you on the outcome
Merry Christmas my friend,,,, and to all the rest out there Happy holidays as well
Randy 

Voodoo:
Thanks, Randy. There's such a lot of good work being done on the board these days, especially with the carriers and carrier ops...it's been said before but I think it needs said again that a big pat on the back is well deserved to everyone out there who's been putting so much back into the AccPack!
Virtual beers and a happy festive season all round!

JamesChams:
Great Job, Mr. "Voodoo"! 8)

Could you, please, do this for Mr. Sylvain Parouty's PA Clemenceau (R 98) v2 French Aircraft Carrier and Flying Stations'
HMS Victorious R38 - Early WWII & HMS Ark Royal IV Carriers?
 
Merry Christmas and a Happy New Year to you! ;)

EDIT: I left the original boat "sim.cfg" files alone and didn't substitute your's for them.  I did, however, backup the original "fx_wake_carrier.fx" and renamed your "voo_wake_carrier.fx" to the same name; I assume that it would have the same effect, correct?  I'm now off to test it. :)

Navigation

[0] Message Index

[#] Next page