Products Support > GSX Support FSX/P3D

A2A Constellation

(1/3) > >>

C130:
Is there a way to get GSX 2 passengers boarding/de boarding the Constelation by A2A?

I have tried to disable the Connie Air stars, in the A2A menu, these are ignored by GSX. Also tried to edit position at airport. (EGLC Orbx) But the GSX stairs don't show up?

Anyone had any success with the Connie and GSX 2?

Regards
David

virtuali:
You must be sure you create a proper GSX configuration for that airplane, with all doors set in their correct 3d position.

C130:

--- Quote from: virtuali on February 05, 2020, 05:38:42 pm ---You must be sure you create a proper GSX configuration for that airplane, with all doors set in their correct 3d position.

--- End quote ---

Yes I created a GSX configuration in the aircraft editor. There is only one passenger door, aft port side. I tried using both embedded stairs and non embedded stairs.

The only other opening is the cargo hatch, which works correctly with the belt cargo loader.

The problem seems to be with the A2A in built boarding routine. They open the door and pop up their own stairway. You can disable this in the sim menu. I have tried every way and can't get GSX passengers to show. The GSX bus arrives, but no passengers appear.

I did see a "flash" of a GSX boarding stairway, but it only showed for about half a second before disappearing. I can't get the GSX stairs to show up in the "edit parking positions" editor, there just aren't any stairs whatsoever?

I would like to get GSX2 working with the Connie, it would make a great video.

Any help appreciated. It's a nice aircraft and lends itself to GSX2. I can't find any videos of anyone using GSX2 with the A2A Connie?

Regards.
David

virtuali:
Try to disable the "Estimate passenger number" option in GSX, and set the number of passengers manually.

ianfisher:
There is a profile for this in the Fourms

Navigation

[0] Message Index

[#] Next page