Developer's Backdoor > GSX Backdoor
some questions
virtuali:
--- Quote from: mroschk on October 12, 2018, 11:34:51 pm ---YYYEEEESSSSS, but look in the first Picture ... GSX point my Nose Wheel of my 737-800 a way too far !!!I never end on the respective line for the 738 !!!!
--- End quote ---
That's because you haven't SET a Stop Position to begin with in the customization page!
As I've explained several times by now, and of course this would have been obvious if you READ the manual, in order for all of this to be working, you must SET a Stop Position, and align the airplane where you want it to be.
If you don't set it, GSX will just place the airplane in the middle of the parking, as it always did, which can be off, depending on how the AFCAD is made.
The obvious reason for this, is that any scenery can be made differently, GSX cannot possibly know HOW the ground texture is made and where the positions are.
--- Quote ---It is not too hard to unerstand, also for you, because it seams you did not know how that works in real Live.
--- End quote ---
It would have been obvious, even for you, if you just paid ATTENTION on what both the manual and I said, multiple times. That was the key sentence in one of my previous replies:
--- Quote ---Precisely for the reason to have different planes stopping their nosewheel on DIFFERENT position, to have the door ending up in a PREDICTABLE position. Which is exactly what's happening now. Provided, of course, you DO set the Stop Position. With any airplane, it doesn't matter, that was the main point.
--- End quote ---
mroschk:
--- Quote ---That's because you haven't SET a Stop Position to begin with in the customization page!
--- End quote ---
Now i havent set the STOP Position ???
For sure i have.
virtuali:
--- Quote ---Now i havent set the STOP Position ???For sure i have.
--- End quote ---
No, you haven't.
If you had, the airplane would stop where you set the Stop Position. No, just scrolling over it with the editor, doesn't mean you set it. You must move it, even a small bit, to have it saved, otherwise it would consider it unchanged from the default, which means "don't use the stop position".
virtuali:
Here's a video showing how it works, when the scenery is made properly and the customization file is made properly with all the Stop Positions set. That's FSDT KLAX.
mroschk:
really, you save a flight and then wrap the plane to the position??
it is not what the problem is !!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version