UK2000 EGKK with PMDG B777-200LR baggage belt?

[cconesa]

Hi all,

I have been unable to change the above aircraft to loaders and containers for cargo. No matter what I do, I always get the conveyor belts that are static and won't go up or down. I tried editing the aircraft but nothing... Please advise.

Thank you.

Christian Conesa.

[virtuali]

I have been unable to change the above aircraft to loaders and containers for cargo.

You are not supposed to change anything. The PMDG 777-200LR is internally supported by GSX, so it doesn't require ANY configuration, and by default it's configured to use only cargo loaders.

The only possible reason why you would get belt loaders, is that you made some kind of mistake trying to configure the airplane that didn't require any configuration to begin with.

Use the Reset button in the airplane configuration page, so GSX will revert to its own internal data, which surely works.

Also, be sure you haven't placed a GSX.CFG file that you might have downloaded (maybe made before GSX supported this plane internally), in the airplane folder. If you have it, you must removed manually, because the Reset button won't remove it (since that location is *supposed* to be used only by airplane developers to supply a GSX config for their plane that won't be reset by mistake)

[Jeeno]

Same issue. 777LR at EGLL UK2000 has baggage belt. The aircraft configuration is the default one and I still have baggage belt. How can I solve?

[virtuali]

The aircraft configuration is the default one and I still have baggage belt. How can I solve?

Your airplane configuration is not default. See my previous reply.

[fabristunt]

I too get that, but only on uk2000 sceneries. It could be a scenary specific problem, because at fsdt jfk and at at defaultor freeware airport it works ok.

[yosm]

I have the same problem.

Only on UK2000 scenery.

downloaded GSX and made no changes whatsoever

[cptbambi]

Guys this is caused by incorrect settings in the Airport position settings, UK2000 airports come with their own GSX config file and in some bays they are set to only allow belt loaders, simply go into the airport position editor and make sure that the check box that sets loader type is set to the "any type" setting, hit apply and it should work as intended.