FLIGHTBEAM NZWN Wellington P3DV5

[gromor]

Animated ramp vehicles on and ramp vehicles set to low. Static aircraft enabled with only General aviation ticked in the config.
If you do not have this you have to change the afcad path name to your active afcad.

Gates 13-17 and 21-29 edited with custom pushbacks. Heavy gates 23,26 edited with 787-9. The others with 737-800.
Stands 9-12 are walk in edited for Dash 8-q400 with pushbacks. 8 and S Parking 7 are with bus.
Gate 72 are walk in edited with 737-600, enter stand from taxiway R. Gate 73 are walk in edited for Dash 8. No pushbacks.

Replace the original SODE xml with my attached Flightbeam_NZWN xml file to get the jetway on gate 23 to work.
Do this in the C:\ProgramData\12bPilot\SODE\xml folder.

Place ini file in the C:\Users\(username)\AppData\Roaming\Virtuali\GSX folder. Delete/Remove&backup other files starting with NZWN.

[F4RIO]

Thank you for creating this package.

I am experienced at installing these packages.

Downloaded and installed as directed (P3DV5.3).

The package does not appear to be active (ex no walker waypoints at Gate 9).

Screen shot of GSX customization page (package installed) attached.

Any suggestions?

[gromor]

Where it says scenery customization available from these sources it should say ......nzwn-gromor.

There are probably another ini file in the scenery folder where nzwn is installed. Check that first

[gromor]

aaaand i notice your active afcad is nzwn_nostatics.bgl.
You have changed that in the second line in my ini file?

[F4RIO]

aaaand i notice your active afcad is nzwn_nostatics.bgl.
You have changed that in the second line in my ini file?

Oh, you mean like it says in the first line of your installation instructions?

Works now. Thanks for the assist and thanks for your work. Flying VATSIM Cross the Ditch tomorrow out of NZWN

[gromor]

glad to help out