FSDreamTeam forum
General Category => Unofficial F/A-18 Acceleration Pack board => Topic started by: herbertsch on June 29, 2008, 11:09:29 am
-
Hello,
I don`t know how to use (NOT) CMD V/S in ACL display; I can only acivate NOT CMD -1800; how to activate CMD and how to change +/- 1800?
Thanks Herbert
-
ACL display is basically just an autopilot annunciator, it simply reflects waht the autopilot is doing, but you don't do anything from that panel. There's no change of Vertical Speed ratio on the F-18 however, is still possible to use the standard FSX autopilot keyboard commands to change the various options, like V/S rate, for example.
-
Hello Virtuali,
thank you very much for your fast reply. But maybe I did not make clear myself when asking before.
So once again (and pls excuse my poor english, I am from Germany): All my keys are on setting standard and ACL shows and the autopilot delivers when i strike
ctrl-r -> CMD A/S xxx or NOT CMD A/S xxx
ctrl-z -> CMD ALT xxx or NOT CMD ALT xxx
ctrl-h -> CMD HDG xxx ort NOT CMD HDG xxx
ctrl-t -> CMD ATTH or NOT CMD ATTH
Now my question is, how to toggle between CMD V/S xxx and NOT CMD V/S xxx
Thanks Herbert
-
Now my question is, how to toggle between CMD V/S xxx and NOT CMD V/S xxx
That's simply the indication if the Master autopilot status. To turn on/off the AP, either select A/P from the Upfront panel, then select ON/OFF, or just use the "Z" command on the keyboard.
-
Thanks,
but it doesn`'t help. Maybe differences in the German Version of FSX? Sind denn keine Vizeeuropameister hier im Forum?
Regards Herbert