FSDreamTeam forum

FS9 support => Honolulu FS9 => Topic started by: Spuddy on September 15, 2023, 08:47:43 pm

Title: Reactivation of PHNL Scenery
Post by: Spuddy on September 15, 2023, 08:47:43 pm

I have reinstalled my PHNL scenery and reactivated it via the Add on Manager. The scenery shows that it has be reactivated. The scenery does display correctly except for the jetways. At some gates their is half a jetway, at some a quarter of the jetway and at some gates nothing. I purchased the scenery on the 13/12/2013 and was allowed 5 activation's. I have reinstalled the PHNL scenery on quite a few occasions and have never experienced. I have FS9.1 installed. Please could you assist me in trying to sort this problem out. Regards

Title: Re: Reactivation of PHNL Scenery
Post by: Spuddy on September 16, 2023, 08:57:06 pm

Problem solved thank you. I did not turn the Honolulu scenery off in AES before reinstalling the scenery again.

Title: Re: Reactivation of PHNL Scenery
Post by: usherp on September 23, 2023, 10:42:43 pm

Hello,
Did you use the new add on manager to reinstall the scenery? I recently had a hard drive replaced so I had to rebuild FS9. I can't get any of the scenery to reinstall. I don't have AES but the steps you took to get the scenery to fully display may be helpful for me. Thanks Philip