FSDreamTeam forum
Products Support => Vancouver CYVR support FSX/P3D => Topic started by: kiekar on January 08, 2020, 08:19:36 pm
-
Hello,
Just ran FSDT Live Update prior to running P3Dv4 and now I have no terminals showing at CYVR except for the jetways.
After rebooting my computer and starting P3D a error message popped up.
couatl v3.2 (build 4292)
panic log started on Wed Jan 8 13:31:07 2020
problem raised by addon <unknown>
Traceback (most recent call last):
File ".\common\dynamicShadows.py", line 135, in refreshObjects
File ".\common\dynamicShadows.py", line 66, in foreachObject
File ".\common\dynamicShadows.py", line 135, in <lambda>
File ".\common\dynamicShadows.py", line 184, in setSunAngle
NameError: global name 'isP3D2orMore' is not defined
{'Airport': 'CYVR', 'User Pos': (49.198565243778006, -123.17395981666179, 8.72311 m, 4.45611 m, 178.00000810700706)}
-
Me too!!
Darcy
-
Fixed by running the Live Update again now.
-
Thank you working now.
Darcy
-
Fixed by running the Live Update again now.
Thanks for the quick fix.
Karl
-
Today I updated and CYVR has no terminal selection. I chose gate 39 and the jetway is misaligned and previous jet way customizations are missing.
-
Today I updated and CYVR has no terminal selection. I chose gate 39 and the jetway is misaligned and previous jet way customizations are missing.
The problem doesn't have anything to do with GSX, CYVR or the Live Update.
When the gate positions don't match, it's usually a problem caused by another AFCAD in conflict. The most common cause of conflicts are those AFCAD supplied with AI traffic products, which are supposed to be used only if you use the default scenery, but must be removed if you have an addon.
You can use the free Simple Airport Scanner utility to search for duplicates AFCAD:
http://www.scruffyduck.org/simple-airport-scanner/4584282795
Or check the name of the AFCAD used by GSX in the parking customization page.
-
This issue was only evident after FSDT update. I re-installed CYVR and the issue went away.
-
I re-installed CYVR and the issue went away.
Our installer places the scenery on top of the Scenery Library, so now has an higher priority to the conflicting file that was causing this. You still have the conflicting file, but if the airport is on an higher layer, it won't cause problems.
It's common knowledge that airports should always stay on top of everything else, which is where our installers place them by default. If you move them, or install other non-airport products that force themselves on an higher layer, you should move the airports back on top.
Or, of course, find the cause of the conflict, remove the AFCAD, so the layering will matter less.
-
The solution I found was to change the library insertion point in Orbx Central to after Fs Dream Team. See attached.
-
The Orbx library insertion points have always been very important to set correctly. FTX airports and regions you want to have set below your bottom-most addon airport and the ORBX Open LC to be below the FTX airports and regions. Once it's done you shouldn't have to ever set or mess with layers again.
-
The solution I found was to change the library insertion point in Orbx Central to after Fs Dream Team. See attached.
A million thanks! That worked like a champ! I was losing my add-on airport scenery for CYVR and CYLW and couldn't figure out why.