Products Support > JFK for FSX/P3D

Run out of memory Problem over New York

<< < (2/3) > >>

Kai-Uwe:
I have These Problems too:

first I give my Settings to you: texture 1024, water effects 3 and LOD 4.5, autogen density sparse. I use the 737NGX and UT2 traffic.
For sceneries I have: FSDT KJFK of course ;) and Megscenery Earth New York and Massachusetts and AS Manhattan 1.30.
I believe that these settings are moderate. Now I start FSX. In process Explorer the fsx.exe grows to about 1GB when the freeflightmenu started. After that I load the NGX. Now this file increases its size to about 1,5GB. After loading JFK and FSX to its surface I have about 3,2GB here suddenly! During starting up the NGX, loading weather via FSGRW, an external program which doesn't affect the fsx.exe and taxiing I quickly reach the 4GB and now the OOM comes. For three times trying to start only one time I was able to bring up the bird into the air. The Crash came after that.
It's very frustrating. I disabled the photsceneries but there was no difference. I can't go below these fsx-settings, it's the Minimum already. What else can I do here?

thanks Kai

virtuali:

--- Quote from: Kai-Uwe on June 17, 2013, 12:48:03 pm ---After loading JFK and FSX to its surface I have about 3,2GB here suddenly!
--- End quote ---

Not caused by JFK, not possible with the texture size at 1024 anyway. I can't reach that even with texture size at 4096. You said you use UT2, perhaps you have too many AI.

You said you use Aerosoft Manhattan. This is what takes all your memory: when you load JFK, you don't load "just" JFK, you also load everything in the area, and the most memory consuming it's surely Manhattan.

Try to disable AS Manhattan, and see the difference it makes.


--- Quote ---loading weather via FSGRW, an external program which doesn't affect the fsx.exe
--- End quote ---

The *program* itself might not take any memory from FSX, but the *things* it creates WILL take memory from FSX so, for example, if that program creates lots of clouds, because of the weather, their will take memory away from FSX, both their polygons and their textures.


--- Quote ---It's very frustrating. I disabled the photsceneries but there was no difference. I can't go below these fsx-settings, it's the Minimum already. What else can I do here?
--- End quote ---

Disable AS Manhattan first, and then try to use DX10. Check your memory consumption then, and draw your own conclusions.

Kai-Uwe:
thanks Umberto, I'll try this.

best regards Kai

Kai-Uwe:
hi Umberto,

yes disabling Mahattan helped, a little bit. I reached 3,2GB again, but it stood stabily. I only was at the terminal, without taxiing. Maybe the load will be increasing then. I'll try this tomorrow.

best regards Kai

OPTIMIST26:
I will try to remove AS mAnhatten X... I have got too...

By the way, I didn't like DX10 mode... Graphics (especially edges) shimmering and serrated (I couldn't be find true world in English)

And I have one question... Where can I find version number of my installed JFK?? I remembered that updated my JFK2 but Today I realised new version???

Navigation

[0] Message Index

[#] Next page

[*] Previous page