Products Support > JFK for FSX/P3D

Crosswind AFCAD Updated!

<< < (2/5) > >>

donaldd:
I don't mean to sound stupid but where to I place these files?

theshack440:
No worries, it depends, do you mean the AFCAD gate assingments modifications and where to do them or the actual AFCAD that hombrexp posted? The original AFCAD up top that is attached to the post goes in the FSX/fsdreamteam/JFK/scenery folder (after you removed the other AFCAD). The modifications to the AFCAD would be done in a program like ADE (airport design editor) or another program of the same kind. Hope that helps.

Regards

donaldd:
He said in this post the he fixed T6 still being open to jetBlue and that the AFCAD would close it. Is that file the one attached to this post and where would I place that one?

hombrexp:
Go to your fsdreamteam folder, open JFK - scenery, then remove (and backup) the file ap_KJFK.bgl.  Then place the ap_KJFK 31 22.bgl file I provided into that folder.  Reload FSX and you the my replacement AFCAD should be inforce.

donaldd:

--- Quote from: hombrexp on April 12, 2011, 06:36:07 am ---Go to your fsdreamteam folder, open JFK - scenery, then remove (and backup) the file ap_KJFK.bgl.  Then place the ap_KJFK 31 22.bgl file I provided into that folder.  Reload FSX and you the my replacement AFCAD should be inforce.

--- End quote ---

The ap_KJFK 31 22.bgl will close T6 and activate the cross wind runways? What about the other file provided in this upload and what do I do with the original file you uploaded on the other post a few weeks (or months) ago?

Navigation

[0] Message Index

[#] Next page

[*] Previous page