Products Support > Honolulu FSX/P3D
Not Pointing Fingers, Just Need Help g3d.dll crash
johndrago:
--- Quote ---I had the very same issue for a considerable time and just like you the problem occured when i bought and installed PHNL, I run UT2 as well. I have no idea what caused the issue but this is what i did to resolve it, in UT2 i turned off GA traffic and moving Jetways and since then i've not had the problem,.....give it a try and see if it helps, i still keep commercial AI at 100%.
--- End quote ---
Interesting. Is it the combo of unchecking the moving jetways and GA traffic, or does just unchecking the moving jetways work too?
Thanks,
John
9Y-POS:
--- Quote from: johndrago on April 07, 2011, 05:16:28 am ---
--- Quote ---I had the very same issue for a considerable time and just like you the problem occured when i bought and installed PHNL, I run UT2 as well. I have no idea what caused the issue but this is what i did to resolve it, in UT2 i turned off GA traffic and moving Jetways and since then i've not had the problem,.....give it a try and see if it helps, i still keep commercial AI at 100%.
--- End quote ---
Interesting. Is it the combo of unchecking the moving jetways and GA traffic, or does just unchecking the moving jetways work too?
Thanks,
John
--- End quote ---
I did them both John, so i believe its the combination, when i tested with just the GA turned off i had the occasional issue but with them both deactivated, it was fine.
Joshsum:
I have read in other forums that sometimes the cause for this is a texture issue with one of your planes or one in UT2. The g3d.dll is a hard one to figure out as many things can cause it to happen.
pete_auau:
yea this ctd is a hard one since can can come up anywhere just go over to orbox forum they got two thread on this type of ctds
johndrago:
--- Quote from: 9Y-POS on April 07, 2011, 04:30:34 pm ---
--- Quote from: johndrago on April 07, 2011, 05:16:28 am ---
--- Quote ---I had the very same issue for a considerable time and just like you the problem occured when i bought and installed PHNL, I run UT2 as well. I have no idea what caused the issue but this is what i did to resolve it, in UT2 i turned off GA traffic and moving Jetways and since then i've not had the problem,.....give it a try and see if it helps, i still keep commercial AI at 100%.
--- End quote ---
Interesting. Is it the combo of unchecking the moving jetways and GA traffic, or does just unchecking the moving jetways work too?
Thanks,
John
--- End quote ---
I did them both John, so i believe its the combination, when i tested with just the GA turned off i had the occasional issue but with them both deactivated, it was fine.
--- End quote ---
I ended up turning off GA traffic, and moving jetways, and it solved the problem for me so far.
John
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version