Products Support > GSX Pro - Airport profiles

Gaya Simulations LOWW

(1/4) > >>

AUA9085:
Hey there,

I just tried to make Gaya Sim. LOWW a bit compatible with GSX.
It was working so far fine. Every Gate has its VDGS but some Gates are unfort. listed twice cause GSX cant different between F and C Gates (with same number)

Gates F3 F9 F11 F17 are not known by GSX therefor they cant be selected yet.
The Jetways are also a bit tricky cause it seems like that LOWW cant be read by GSX cause of its type of installation into the community folder.

Whatever, here is the link, you can test it out :)

NOTE: This version is for the Steam Version. If you are using another version, change the AFCAD path in that file
Download: https://flightsim.to/file/39200/gaya-simulations-loww-vienna-gsx-profile

Cheers
Bernd

Hanse:
Hi Bernd,

Thanks for all the work. But people downloading the file should consider to change the position of the "afcad_path" in the file based on their settings. My settings are (MS edition and not STEAM edition) afcad_path = \\?\?\?\Official\OneStore\fs-base-genericairports\scenery\0601\APX52140.bgl.

Regards,
Rolf

AUA9085:
Thanks for the hint, i'll add that its for the Steam Version :D

virtuali:
Don't worry, we already took this into account, quoting from GSX Manual, Page 46:


--- Quote ---The name of the .BGL used to customize the scenery is listed in the [GENERAL] section of the GSX .INI profile. It will include the complete path valid for your system but, don’t worry, there’s no need to edit it out before sharing your work, since GSX will only use the .BGL filename, and will ignore the full path altogether, it has been designed like this exactly to facilitate sharing of GSX .INI profiles without worrying about different paths. As long the currently active .BGL matches the name referenced in the .INI file, the .INI will be loaded by GSX, no matter the path.
--- End quote ---

Hanse:
Hi Bernd,

did you also try to edit "Pushback" for the various gates? I am asking because I had problems at F23 and needed it to customize.

Regards,
Rolf

Navigation

[0] Message Index

[#] Next page