Products Support > GSX Support MSFS

Issues to report

<< < (2/2)

Bentree:

--- Quote from: virtuali on August 21, 2022, 05:12:11 pm ---
--- Quote from: Bentree on August 21, 2022, 04:55:08 pm ---After P/b truck is connected to the aircraft nothing happens anymore...... i had to start the engines and just taxi away without being pushed back..
--- End quote ---

Were you using the -600 version ? There's no configuration for it yet, we need to provide with one, before you can use it in GSX. The -700 is fully supported.


--- Quote ---After landing at LOWS (Digital Design Salzburg airport), the ground handling was oke but the suitcases on the luggage cars disappear depending on the viewers viewpoint.
--- End quote ---

Completely normal, it's the simulator that decides to optimize objects based on their size. It usually goes away if you move the camera a bit back.

--- End quote ---

I was using the 700 version (i don't have the 600).

Thanks for your reply!

virtuali:
Did you had the Toolbar icon active at that time ? Maybe GSX was trying to tell you something, but you missed it because you closed the panel.

Bentree:
Thanks for your reply...yes i did.....but clicking the toolbar icon does not always result in an active GSX menu...in fact this time it didn't come up.

There was noting GSX wanted to tell me (no beep sound for that also)....in fact, i restarted caoutl after this happened the first time and that resulted in the same situtaion, where after i decided to juist taxi away (couldn't close the active GSX situation).

Navigation

[0] Message Index

[*] Previous page