Products Support > Mesh for MSFS
FSDT releases Switzerland Mesh for MSFS 2020
tajimak:
Thanks for your quick attention. It is fixed now.
johann724:
Hi
I am very happy with the Swiss Mesh. Well done!!
However I miss the Monte Rosa alpine hut as well as the tower and the structures on the summit of Säntis. I hope for a future update that will incorporate these buildings.!
rick66:
Umberto, I found a spike using the 10mtr mesh, Not sure of the coordinates but it's just near Zurich heading into the Alps.
https://imgur.com/wTK2Wf9
virtuali:
--- Quote from: rick66 on May 27, 2021, 07:46:14 am ---Umberto, I found a spike using the 10mtr mesh, Not sure of the coordinates but it's just near Zurich heading into the Alps.
--- End quote ---
Well check that. Have you tried if it happens with the 20m version too ?
rick66:
--- Quote from: virtuali on May 27, 2021, 09:40:01 am ---
--- Quote from: rick66 on May 27, 2021, 07:46:14 am ---Umberto, I found a spike using the 10mtr mesh, Not sure of the coordinates but it's just near Zurich heading into the Alps.
--- End quote ---
Well check that. Have you tried if it happens with the 20m version too ?
--- End quote ---
Not yet, just installed it now so i''l have a look.
Edit: 20m is fine no spikes, But i did find LSZC(Home of Pilatus) has the foothills behind sliced, Maybe you can't fix it because of the location of the airport and your tile method. All good though, I've flown most of the Alps today and these were the only anomalies i found with 10m.
Nice Job.
LSZC https://i.imgur.com/nGWGfyc.jpg
No spikes 20mt https://i.imgur.com/gU34a2J.jpg
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version