Products Support > JFK for FSX/P3D

JFK V2

(1/2) > >>

unc1rlm:
I installed today 3-10-17 JFK V2..file details says 2.4xxx and it asked if I wanted to install afcad which I did. When I go to airport and want to select an item..it lists runways and nothing but cargo ga ramps..no gates or anything for commercial aviation..etc. Can someone tell me what to do to get it back to the commercial side gates etc.

Thank you Umberto for a great product!!

Best Regards,
Bob M.

gcrewmc:
Are the gate assignments like 415, 702 etc.?

virtuali:
It's likely you have another AFCAD from another product in conflict. Most likely, an AFCAD that came with an AI traffic package, like MyTraffic or similar, which contains an AFACD that should be used only if you have the default JFK.

You can use the Simple Airport Scanner free utility to search for AFCAD conflicts, and remove them.

unc1rlm:
Thanks Everyone :)

Bob M.

unc1rlm:
new at this afcad business. I used the airport scanner for say jfk.. It lists 2 folders Layer 140..points to D:\FsDreamteam\KJFK\scenery\appr_KJFK.BGL  and second folder is identical except after scenery\KJFK_FSDT.BGL   is that right. In JFK it lists runways...then GATE 101--RAMP GA..numbered and the GATE 220--RAMP GA/ then later Parking etc..mostly GA and Cargo.  I know kennedy has 8 terminals and each has designation like Terminal 1- G01 etc  then Terminal 3  01,02 etc..   Maybe making something of nothing but just wanted to have the right stuff. I did uninstall and reinstall and the dropdown was the same.

Thanks for any enlightenment..
Warmest Regards,
Bob M.

Navigation

[0] Message Index

[#] Next page