Products Support > Dallas FSX/P3D
Couple things with the ground textures
cmpbllsjc:
Umberto,
I must say I am very happy with this scenery. Great FPS and the LOD'ing seems to be the best yet. However I am having a couple funny things with the ground textures when I am arriving and leaving the airport. Here's a few screens to show what I get. Seems like a bit of flickering on the ground and the runways seem to be a little blurry in the middle when appraoching. I am also getting some funny flashing of white through the textures.
abrinson:
Looks like Direct X 10 problem. Not sure.
cmpbllsjc:
--- Quote from: abrinson on August 06, 2010, 11:52:35 pm ---Looks like Direct X 10 problem. Not sure.
--- End quote ---
Cant be that. I am on WinXP 32 bit, no DXT10 option available.
virtuali:
No, it's not a DX10 problem. What was your altitude ?
cmpbllsjc:
--- Quote from: virtuali on August 06, 2010, 11:55:44 pm ---No, it's not a DX10 problem. What was your altitude ?
--- End quote ---
Around maybe 1000'. Dont remember for sure but I had just taken off, so the shots were as I was getting higher.
Is there any particular mesh setting needed? Maybe like a bleed thru problem. Currently using FSGS mesh.
Navigation
[0] Message Index
[#] Next page
Go to full version