Author Topic: GSX Pro - Loaders Setup  (Read 2102 times)

SinanSarpE

  • Newbie
  • *
  • Posts: 2
GSX Pro - Loaders Setup
« on: October 15, 2022, 11:25:19 am »
Hi there,
I would like to ask for if it is possible to force -on software side-  "loaders type" at arrival airport according to departure airport "loaders type". Because once you have loaded by Conveyor Belt it is expected that you will be unloaded by same type as well.

What do you think?
« Last Edit: October 15, 2022, 11:34:16 am by SinanSarpE »

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 50659
    • VIRTUALI Sagl
Re: GSX Pro - Loaders Setup
« Reply #1 on: October 17, 2022, 01:19:28 pm »
The loader type preference is something that should normally be set in the airplane configuration, so it will always be the same at all airports.

The one and only reason why you would want to specify the loader the in the parking customization, is in very rare cases, where there's not enough physical space in the parking spot for the loaders to maneuver, so one of them might required to be disabled, usually the front one. Yes, it allows to change the loader type from the one used by the airplane, instead of just letting disable/enable whatever loader is configured for the airplane, but it should be up to you to use that option to also change the loader type.