Author Topic: Aerosoft ENTC & ENBR (Tromsø and Bergen) Walk in GSX config  (Read 1997 times)

gromor

  • Jr. Member
  • **
  • Posts: 65
Aerosoft ENTC & ENBR (Tromsø and Bergen) Walk in GSX config
« on: March 20, 2022, 05:14:39 pm »
Hi.

Found out that these V4 sceneries work well in V5. Just point the installer to main P3d folder and it will install it in the ecosystem folder.
So these should also work for the V4 people.

ENTC: Have static aircraft and dense equipment unticked. Gate 20 is the only walk in and is configured for Dash 8.
All other gates are jetway/bus. All vehicles/pushbacks edited.

ENBR: Have Static Aircraft unticked. Terminal 3 Does is not modelled so Terminal 2 gates are edited and pushbacks are checked.
Some of the 40 stands are walk in (41-43). The rest are bus. These are also Dash friendly as they park here IRL.
Stand 1-10 are edited and pushbacks are checked.

 I Use the default sode jetways in both sceneries as they look ok. As always with these old Sode jetways, the passengers will walk up over the jetways but it's not to bad.

Place the ini files in C:\Users\(username)\AppData\Roaming\Virtuali\GSX
Make sure to remove other ini files starting with entc and enbr in this folder.

Regards.
« Last Edit: March 21, 2022, 10:12:57 pm by gromor »