Author Topic: Aerosoft ENVA V2 Walk in GSX Config  (Read 286 times)

gromor

  • Newbie
  • *
  • Posts: 40
Aerosoft ENVA V2 Walk in GSX Config
« on: March 02, 2022, 12:28:07 am »
Hello.

A lot to do on this one!

First i found that the GSX vehicles was under ground due to the Afcad name not being recognized by GSX. I found this fix on the Aerosoft forums: https://forum.aerosoft.com/index.php?/topic/157059-enva-elavation-issue/page/2/
This might just be a V5 issue so if you use V4 this might not be needed.

Next i was sick of when i boarded the passengers they spawned above the Jetway and walked down. Looked stupid. The GSX solution to getting their Jetways on this airport is not ideal, but i think it's the best looking option.

Gates 30-37 with new jetways.
Gates 25-28 and 38-45 are now walk in gates. Gate 41 is numbered 47 in this scenery.
Gates 25 and 39 is made for Majestic Dash 8. Do not use these gates for 737/320/CRJ etc.
All vehicles and pushbacks are edited on all gates.

Open the Værnes V2 - Configuration Tool

Set Sode Jetway animation to off

Set static aircraft to off (I use AIG/Vatsim for traffic so i prefer to turn it off.)

Leave SODE VDGS on as i use this. If you do not have this the gates with jetways will not have edited parking systems by me.
Save changes.

Go to where you have installed the airport and open the scenery folder. Change the ENVA_Library_StaticJetways.bgl  file to ENVA_Library_StaticJetways.off

Using the aerosoft forum solution rename ENVA_ADEP4_ADE.bgl to AFX_ENVA.bgl

Place the ini file in C:\Users\(username)\AppData\Roaming\Virtuali\GSX
Make sure to remove/backup other ini files starting with enva in this folder.

Regards