KLAX active but not showing

[IanHarr]

I have a strange problem. KLAX is installed and active according to the add-on manager. When I start at KLAX everything is there and fine.
However, arriving at KLAX yesterday after a 12 hour flight, there were no textures, no buildings, just a coarse representation of the ground.
This morning, when I start there, everything is fine again.
What could be wrong with my setup?

[virtuali]

Something about your configuration might be useful, like:

- the simulator used

- the airplane used

- if you have GSX installed

- if the GSX menu was still visible in the Addons menu when you landed

[IanHarr]

Prepar3d v5.3 plus HF and HF to the HF.
Aircraft PMDG 744 QOTSII
GSX had stopped working during take off and was not available on landing.

[virtuali]

What do you mean with GSX stopped working during takeoff ? Have you seen some kind of error message ? If yes, which one ?

[IanHarr]

I mean just that! For the first time ever, GSX just froze as it was completing loading. Passengers were loaded but the last container just stuck and the action menus both normal and top could not be activated at all. In the end, I disabled GSX, that command worked, and reversed out using Shift +p. The container just stayed hanging in the air. Everything else worked.

[virtuali]

In the end, I disabled GSX, that command worked

If you mean you chose "Disable" from the GSX menu, that will disable GSX and, will likely cause airports requiring it stop working. When GSX stops for any reason, the correct command to use is the "Restart Couatl" from the Couatl Settings menu.

You should Enable GSX back now.