Author Topic: no Jetways and no GSX working  (Read 3228 times)

marcd

  • Newbie
  • *
  • Posts: 4
no Jetways and no GSX working
« on: November 26, 2019, 09:21:04 pm »
I installed KORD v2 nad all the Jetways are missing and GSX is not working.
Before i used DD KORD and deacttivated the scenery and deletet all files in the P3D Folder and deleted the SDX Files in Sode.
What else can I try to fix this?
Thanks a lot

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 50659
    • VIRTUALI Sagl
Re: no Jetways and no GSX working
« Reply #1 on: November 26, 2019, 11:28:53 pm »
You don't have to do anything manually ( in fact, it's best if you don't ), to disable DD KORD, it's enough to launch the DD installer, and De-select O'Hare, leaving the others enabled, so it will do all the required clean up, including the SODE files for KORD only.

In any case, missing jetways at KORD are likely caused by an AFCAD conflict, most likely from another scenery of the same airport. If you open the "customize airport positions" from the GSX menu, it will tell you which AFCAD is in use, which will give you some idea of the conflicting file.

marcd

  • Newbie
  • *
  • Posts: 4
Re: no Jetways and no GSX working
« Reply #2 on: November 26, 2019, 11:41:47 pm »
First of all thanks a Lot.
I tried to disable DD KORD first, but then there were the old jetways from DD still in the scenery..
The "Customize Airport Postion" is not available at my KORD scenery right now, at other airports it is working correctly... so i can't use GSX at the moment at KORD 

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 50659
    • VIRTUALI Sagl
Re: no Jetways and no GSX working
« Reply #3 on: November 26, 2019, 11:46:21 pm »
Try to select "Restart and Reset the airport cache" from the Couatl settings menu, and see if the GSX menu comes back.

marcd

  • Newbie
  • *
  • Posts: 4
Re: no Jetways and no GSX working
« Reply #4 on: November 26, 2019, 11:52:49 pm »
tried this already... nothing changes... sometimes the international terminal dissapears after the reset.

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 50659
    • VIRTUALI Sagl
Re: no Jetways and no GSX working
« Reply #5 on: November 27, 2019, 12:35:38 am »
Try this:

- Exit the sim

- Run the FSDT Live Update

- Restart.

marcd

  • Newbie
  • *
  • Posts: 4
Re: no Jetways and no GSX working
« Reply #6 on: November 27, 2019, 08:17:32 am »
I run the live update already and did a reinstallation of the scenery but nothing changes.. no jetways are visible..

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 50659
    • VIRTUALI Sagl
Re: no Jetways and no GSX working
« Reply #7 on: November 27, 2019, 05:33:27 pm »
Are you sure you installed KORD V2 ? Try again.