Author Topic: Question about Jetways  (Read 3773 times)

torsten

  • Full Member
  • ***
  • Posts: 211
Question about Jetways
« on: November 02, 2019, 11:03:51 pm »
Hello,

one question:

I have a Position with a Jetway. IN Gsx it is set up not to use Stars ( Disable staircases )
But when i have connected the Jetway to the airplane and then ( as of any reason ) must do a "Reset Position" from the GSX MenĂ¼ and when
i after that request Boarding or Deboarding, why is GSX then asking to open the AFT PAX ? ( there is no Jetway and no Stair )

Torsten


virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 50643
    • VIRTUALI Sagl
Re: Question about Jetways
« Reply #1 on: November 04, 2019, 01:51:19 pm »
I tried it now, and it doesn't happen. This is what I did:

- Went to an airport in which I replaced default jetways with GSX jetways ( I assumed this is what you mean with "I have a Position with a Jetway. IN GSX" ), in this case it was Simwings LEMD, Gate 71

- Select "Disable Staircase" in the parking customization page. Pressed Apply.

- Selected Deboarding. Jetway menu came, docked to Exit 1, no rear stairs appeared and the only door request I got was for the main Exit 1, as expected

- While passengers were still exiting, I chose "Reset Position"

- Selected Deboarding again. Jetway menu came, docked to Exit 1, no rear stairs  appeared and the only door request I got was for the main Exit 1, as expected

torsten

  • Full Member
  • ***
  • Posts: 211
Re: Question about Jetways
« Reply #2 on: November 04, 2019, 07:43:25 pm »

- Selected Deboarding again. Jetway menu came, docked to Exit 1, no rear stairs  appeared and the only door request I got was for the main Exit 1, as expected


i maybe did not explain good enough...sorry

Let the Jetway connected to the airplain, do not disconnect it after reseting the position.
That is it maybe.

Later this evening i will do a little video, so you can see it better.

Torsten

torsten

  • Full Member
  • ***
  • Posts: 211
Re: Question about Jetways
« Reply #3 on: November 04, 2019, 08:58:47 pm »
oh je...i think it was my mistake....
I have installed a EDDP AddOn Scenery which have SODE Jetways, but not GSX SODE Jetways...
With Sode jetways it is possible that the Jetway stays connected to the Airplane if you reset the position in GSX.
But with GSX Jetways that is not possible...

Solved



Thanks
Torsten
« Last Edit: November 04, 2019, 09:37:28 pm by torsten »

torsten

  • Full Member
  • ***
  • Posts: 211
Re: Question about Jetways
« Reply #4 on: November 04, 2019, 09:37:42 pm »
But as i describet above, with sode jetways, when the Jetway is still connected to the Airplane, and i reset the position, then i ask for boarding or deboarding,
GSX ask me to open the aft pax door

Captain Kevin

  • Beta tester
  • Hero Member
  • *****
  • Posts: 1634
  • Captain Kevin
    • Captain Kevin
Re: Question about Jetways
« Reply #5 on: November 05, 2019, 01:10:43 am »
I'm thinking the GSX jetway is considered a position, so when you reset the position, it got reset with it.
Captain Kevin

torsten

  • Full Member
  • ***
  • Posts: 211
Re: Question about Jetways
« Reply #6 on: November 05, 2019, 06:43:46 am »
Yes, but why is GSX asking me to open the AFT PAX ??

Captain Kevin

  • Beta tester
  • Hero Member
  • *****
  • Posts: 1634
  • Captain Kevin
    • Captain Kevin
Re: Question about Jetways
« Reply #7 on: November 05, 2019, 01:21:42 pm »
No idea.
Captain Kevin