Small problem with GSX level 2

[SunDevil56]

So I have used GSX Level 2 successfully to re-configure a number of my add on airports with SODE jetways, it's a powerful tool and i'm very happy with it. I'm running P3D 4.3

But i'm having a small issue with LatinVFR KRDU Raleigh Durham... I have re-configured the entire airport, every available gate that has a jetway, with GSX L2 jetways, but here's where the problem arises...

If I start the sim and go directly to KRDU there isn't a single jetway in sight (see attached pic), but if I start the sim and start at any airport other than KRDU, and then switch to KRDU from there, the jetways are all there.... (see also pic attached)..

https://imgur.com/lnGhzrr

https://imgur.com/yrD4jsr

This a very odd thing, i'm not having this issue with any other airport i've re-configured with GSX L2, and i'm at a loss to figure out what might cause this to happen. Any assistance or suggestions are  appreciated. Thanks.

[virtuali]

Check if the correct AFCAD has been loaded when the simulator starts ( opposite when you fly there ). In the GSX parking customization, the name of the AFCAD in use is listed.