Author Topic: There is a possibility to open only the front and back left doors on default 737  (Read 4191 times)

adrian67

  • Newbie
  • *
  • Posts: 3
 ??? There is a possibility to open only the front and back left doors on default 737 on GSX? Each time I must press Shift +E+3 to open the left back door but in that case it will be open also the right front and right back door. I want to know if there is any possibility to open only the left or right doors. Thank you and I'm sorry if is a silly question. ;)

Eisbahn

  • Full Member
  • ***
  • Posts: 139
This action is built into the model file and has nothing to do with GSX.

adrian67

  • Newbie
  • *
  • Posts: 3
I know that, there is any solution to modify the cfg file of the default 737-800 to open separately the doors, or two on the right and two on the left?

torsten

  • Full Member
  • ***
  • Posts: 211
it is not possible to configure that in the aircraft.cfg.
The doors of a aircraft are modelled in the *.mdl file and you can not edit that file.

I am also searching for a long time for a B737-800NG WL model where i can open all Doors,
but i did not found any.
You find only payware models like PMDG/iFly or domething, but this models are not working
with Prosim737. But the Prosim model v1.x has no Flex Wings modelled and also the model is not of
a high quality.

adrian67

  • Newbie
  • *
  • Posts: 3
Thank you!  :-[

pilotwings

  • Newbie
  • *
  • Posts: 2
You need to Assign your doors to X1234 that will open each door for you hope that helps.

torsten

  • Full Member
  • ***
  • Posts: 211
you mean the Eits section in the aircraft.cfg?
that is already done :

[exits]
number_of_exits = 4
exit.0 = 0.2,  40.32, -5.38,  3.97, 0   // Front left door
exit.1 = 0.2, -54.10, -4.76,  4.16, 0   // Rear left door
exit.2 = 0.2,  -41.14, 4.00,  -1.31, 1   // Rear cargo
exit.3 = 0.2,  26.21, 4.46,  -1.94, 1   // Front cargo

but i think the door animation is maybe configured in the mld file?

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 50659
    • VIRTUALI Sagl
but i think the door animation is maybe configured in the mld file?

Exactly, there's no way to separate the passenger back door from the service doors on the right side of the default 737 without recompiling/tweaking the .MDL file, to assign a different control variable to them.

I think this should be possible with the ModelConverterX utility

torsten

  • Full Member
  • ***
  • Posts: 211
Thanks, i will try :-)

torsten

  • Full Member
  • ***
  • Posts: 211
Thanks for the tip with the Modelconverter...it works !!

Cool, Thanks