Only half the airport showing, ground textures

[Locarno1]

Hi FSDT,

I've just loaded up in KLAX after not using it for a while and have noticed that it's only showing half the airport.. It shows the full airport but only half of it with ground textures, the other half with the base map and no taxiway markings or runway markings. There's a few buildings but nothing else..

I have ORBX Southern California installed so this maybe causing the issues?

Regards,

Tristan

[virtuali]

I have ORBX Southern California installed so this maybe causing the issues?

Can you disable it to see if this is the case ?

[Locarno1]

I have ORBX Southern California installed so this maybe causing the issues?

Can you disable it to see if this is the case ?

Umberto,

Thanks, when de-activating the ORBX region, the full airport shows..

Many thanks,

[Locarno1]

Hi FSDT,

Any other suggestions at all? I've also tried uninstalling, re-installing and updating Add-on Manager.

Many thanks,

[Psybear]

I had the same issue a while back but If you go to the Orbx site they explain what to do, Sorry, but I misplaced the link.

Clayton

[virtuali]

Any other suggestions at all? I've also tried uninstalling, re-installing and updating Add-on Manager.

What would be the point of doing this, when  you already assessed the problem was caused by OrbX ?

[antonmorse]

I know this post is a few months old, but during a re-install I've been searching for the same info & I thought it was worth posting the link to the Orbx solution here as it might be useful to others.

https://orbxsystems.com/forum/topic/107942-sca-compatibility-with-fsdreamteam-klax/?tab=comments#comment-971420

It explains how to deactivate some Orbx files that interfere with the FSDT KLAX and KLAS airports.