Below are the coordinates that align GSX with the BlackBox Simulations Airbus A318. Just input these coordinates into the aircraft settings in GSX. If you have any issues or find better coordinates, please post them in the comments. Thank you.
----- BlackBox Simulations Airbus A318 -----
NOSEGEAR
Nosegear Distance 8.40
PASSENGERS DOOR #1
Door with custom open/close checks
Name Main Exit
Custom Check (L:BB_LDoorPax1,bool)
Position -2.30 9.10 3.80
Angle 2.00
CARGO MAIN DOOR
No door at this position
PASSENGER DOOR #2
No door at this position
ENGINE #1
Position -5.80 4.00 2.12
PASSENGER DOOR #3
No door at this position
PASSENGER DOOR #4
Door with custom open/close checks
Name Rear Exit
Custom Check (L:BB_LDoorPax4,bool)
Position -2.10 -9.50 4.05
Angle -10.00
WATER
Position 0.00 0.00 0.00
Lavatory
Position 0.00 0.00 0.00
SERVICE DOOR #1
No door at this position
CARGO DOOR #1
Door with custom open/close checks
Name Front Cargo Door
Custom Check (L:BB_DoorCargoFwd,bool)
Position 1.18 6.58 2.56
Angle -25.00
ULD Code BELT
ENGINE #2
Position 5.80 4.00 2.12
DEICER IN
Position 2.90 -0.80 3.50
DEICER OUT
Position 16.50 -5.25 5.10
FUEL
Position 9.34 -1.70 3.78
CARGO DOOR #2
Door with custom open/close checks
Name Rear Cargo Door
Custom Check (L:BB_DoorCargoAft,bool)
Position 0.80 -6.00 2.56
Angle 5.00
ULD Code BELT
SERVICE DOOR #2
Door with custom open/close checks
Name Rear Service Door
Custom Check (L:BB_RDoorPax4,bool)
Position 1.90 -9.80 4.05
Angle 10.00
