GSX and the Q400 in P3D v4

[DoverEightMike]

I have a couple of issues with the Q400 and they way GSX interacts with it in P3D v4.

• When deboarding, the process seems to complete successfully, but constantly stays at "unloading baggage" and therefore no other services can complete.
• When catering is finished, the vehicles never despawn, and it sticks at "Catering vehicles are on their way," so no other services can complete again.
• When boarding is requested, two baggage trains appear, the first doing it's own thing on the right-hand side of the aircraft, which GSX seems to listen to for when boarding is complete, and the second one, which goes to the right place and loads bags correctly, but GSX ignores when stating boarding is complete.

Perhaps these can be fixed with a small live update?

Regards,
Calum Shepherd

[virtuali]

I have a couple of issues with the Q400 and they way GSX interacts with it in P3D v4.

You mean you don't have the problems with the pre-V4 versions of the airplane ?

[DoverEightMike]

I have a couple of issues with the Q400 and they way GSX interacts with it in P3D v4.

You mean you don't have the problems with the pre-V4 versions of the airplane ?

Sorry, should have specified this. The catering issue was present in FSX:SE but that was all.

[DoverEightMike]

On a side note, the vehicles seem to be even worse at driving through other vehicles and particularly the user aircraft in this new update, especially the front baggage loader on the FSL A320 (not tested with a 737). It does a full circle of the aircraft before driving to the FWD right hand baggage compartment from the left hand side of the aircraft, driving through the aircraft and performing an on-the-spot 180-degree turn, before connecting successfully.

[virtuali]

especially the front baggage loader on the FSL A320 (not tested with a 737).

Are you sure it's the *loader* you are referring to, and not the *train* ?

[DoverEightMike]

Are you sure it's the *loader* you are referring to, and not the *train* ?

Absolutely positive that it’s the loader. But the trains like to drive through themselves / each other a lot too.

[DoverEightMike]

Any update regarding these issues?