Author Topic: Textures gone while in replay mode after landing  (Read 3204 times)

divinglyc

  • Newbie
  • *
  • Posts: 31
Textures gone while in replay mode after landing
« on: September 13, 2017, 05:45:31 pm »
Hi! I have recently installed KJFK v2 for my P3D v4.
However, I have found an issue. After I land and start the replay mode, I found that all the texture of the airport including all the rwy and terminals were all gone.
It would come back to normal after I exit replay mode. I have attached the screenshot for your reference.
What can I do to fix it? BTW, it happened to my KLAX, too.
Thanks!

divinglyc

  • Newbie
  • *
  • Posts: 31
Re: Textures gone while in replay mode after landing
« Reply #1 on: September 13, 2017, 06:00:57 pm »
Well, after searching in the forum, I have found many posts regarding this. :P
I should have searched for them beforehand. :P
My question is, so far this cannot be fixed, right?
Thanks!!

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 50653
    • VIRTUALI Sagl
Re: Textures gone while in replay mode after landing
« Reply #2 on: September 23, 2017, 09:31:33 am »
My question is, so far this cannot be fixed, right?

Not really, unless the sim would be updated to include programmatically-created Simobjects during replay, which would be very complex to do, since the sim would need to record every command sent by apps from Simconnect.

However, while years ago this would be only a problem with our sceneries, nowadays many developers use programmatically-created Simobjects to create sceneries (every scenery using SODE, for example) so, the issue is now shared by several other sceneries, so the best solution it's find alternative ways to record a reply.

I believe FS Recorder used to work, but it hasn't been updated for P3D V4. There's a new program out there, called Flight Control Replay, but I can't say if it's able to record Simobjects too.