« previous next »
Pages: [1]

Author Topic: Qantas at T4  (Read 3720 times)

DMac10121

  • Jr. Member
  • **
  • Posts: 89
  • Boeing + Bombardier
Qantas at T4
« on: April 27, 2015, 06:28:41 am »
Simmers,

Had a quick question regarding the AFCAD for KLAX. I have ADE installed, but unfortunately do not have the SDK installed, and therefore I cannot do this myself. Was wondering if there was an updated AFCAD out there with QF at TBIT instead of T4. I can never park while flying AA, as all of the spaces have been (unrealistically) taken up by 747s and A380s. On that note, AS being at T3 is another point of contention, but that's just a trifle.

Thanks for any and all help!

Regards,

Derek
Logged

pilot3033

  • Full Member
  • ***
  • Posts: 125
Re: Qantas at T4
« Reply #1 on: June 07, 2015, 05:20:43 pm »
Months later, but I can probably do this for you if you'd like. Any other gate changes you'd like to make? Add AAL or AWE/USA gates to T6 along with ASA?
Logged

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 50700
    • VIRTUALI Sagl
Re: Qantas at T4
« Reply #2 on: June 07, 2015, 08:55:37 pm »
Even if you don't have the SDK to compile a .BGL, you can verify yourself with ADE, that the AFCAD that comes with KLAX *DOES* have QFA assigned to ALL parkings at TBIT.

They are *also* assigned to T4, and that is also correct, according to real life, as you can check on the airline assignment diagram at Page 11 or the KLAX manual.
Logged
Pages: [1]
« previous next »