« previous next »
Pages: [1]

Author Topic: PHLI elevation problems  (Read 5135 times)

jcm3mia

  • Newbie
  • *
  • Posts: 3
PHLI elevation problems
« on: August 07, 2014, 03:18:41 am »
I just purchased the Hawaii package. There seems to be an elevation issue in PHLI. The airport seems to be sunken into a bowl but parts of it are like 20 feet higher. I have an almost pristine setup except for 2 ORBX products; FTX Global base pack, ORBX FTX Global Vector and the Pilot's Global Mesh FTX compatible.

Do you have an idea what could be causing the altitude issue?

Joe
Logged

Dave_YVR

  • Beta tester
  • Hero Member
  • *****
  • Posts: 798
Re:
« Reply #1 on: August 07, 2014, 06:53:30 am »
Have you run the global vector elevation correction since installing HLI?
Logged

jcm3mia

  • Newbie
  • *
  • Posts: 3
Re: PHLI elevation problems
« Reply #2 on: August 07, 2014, 04:02:57 pm »
No, I have not. That software is new also and I haven't had a chance to read the pdf. Going to do it right now and get back to you. Thanks.
Logged

jcm3mia

  • Newbie
  • *
  • Posts: 3
Re: PHLI elevation problems
« Reply #3 on: August 07, 2014, 05:21:15 pm »
I didn't realize it was ORBX that I needed to adjust, all's well now, thanks for the help.
Logged

stook2005

  • Newbie
  • *
  • Posts: 11
Re: PHLI elevation problems
« Reply #4 on: February 17, 2015, 05:54:42 am »
You should also get the following AFM - Aerodrome Flattening Meshes.  It fixed a few elevation issues caused by FS Global 2010 that ftx vector cannot fixed.


http://www.fly2pilots.com/cms/Ui/Pages/Products/MainPage.aspx?id=d3fca479-6c4c-465b-bd75-97445878ae48
Logged
Pages: [1]
« previous next »