FSDreamTeam forum

Cloud9 Support => Phantom => Topic started by: MJDykas on July 11, 2010, 03:15:18 am

Title: Troubles with serial registration
Post by: MJDykas on July 11, 2010, 03:15:18 am

   I just purchased the Phantom the other day. I downloaded the loader as required. I installed the file and started FS2004. I selected the Cloud9 Phantom and it thens loads up.  When the plane finally loads it tells me my trial period is starting. I then hit the ALT key and go into Add on menu, select cloud9, phantom, and select enter serial #. When I do that my screen goes black. I have to minimize fs2004 by hitting the windows key.  At that point I see a little box telling me to type in my serial. I copy the serial directly from my proof of purchase email, and paste it in and hit enter. The box goes away, but when I try and get back to FS2004 my screen is again black. Sometimes I can can get the FS2004 top menu bar back on, but it will not allow me to select anything, when I do it just locks up again.  I'm running windows 7 64 bit. Everything else works fine in FS2004. Any help would greatly be appreciated. I would like to get the F104 too, but first I need to get this Phantom working

                                                                                                                          Thanks
                                                                                                                             Mike

 

Title: Re: Troubles with serial registration
Post by: virtuali on July 11, 2010, 10:20:21 am

As explained in the Cloud9 and FSDT installation manuals, when doing the registration, it's best to put FS9 into Windowed mode (ALT+Enter), because on some video drivers have trouble displaying a standard Windows dialog box in Full screen. You can go back to Full screen after the registration.

Title: Re: Troubles with serial registration
Post by: MJDykas on July 29, 2010, 01:52:24 pm

Thank You !!!       It was my fault for not reading the instructions, everything works fine now.