FSDreamTeam forum

FS9 support => Las Vegas FS9 => Topic started by: Kelleymoe on May 05, 2010, 05:00:03 am

Title: Ground Showing Through Concrete
Post by: Kelleymoe on May 05, 2010, 05:00:03 am

Today, I departed Gate E5 and headed towards Rwy 19L.  As I approached the end of the runway, the ground turned from concrete color to green (as seen from the cockpit).  I thought maybe my a/c lights were interfering so I turned them off and still green.  I lined up on the rwy and everything was green around the a/c. Even the markings disappeared as I taxied.  Once I started down the runway, everything turned back to concrete color.  If I used the spot view, everything was fine.  It only happened from the cockpit view and at this area.

Any idea what's causing this?  I don't have any other KLAS AFCADs or scenery installed.

Thanks,

Mike Franks

Title: Re: Ground Showing Through Concrete
Post by: virtuali on May 05, 2010, 11:43:46 am

Quote from: Kelleymoe on May 05, 2010, 05:00:03 am

Any idea what's causing this?  I don't have any other KLAS AFCADs or scenery installed.

The only thing that can cause this, is another scenery. Either it's an AFCAD, or it's a mesh. You might have a conflicting AFCAD, even if you haven't installed yourself, since they usually come with AI Traffic packages, like My Traffic or similar.

I assume, of course, you have the current version of KLAS  (1.1)

Title: Re: Ground Showing Through Concrete
Post by: Kelleymoe on May 06, 2010, 02:12:42 am

Thank you for the advice.  I've checked and I can't find another KLAS AFCAD.  I bought KLAS last Friday, so I'm assuming it's 1.1.  I'll start deactivating scenery until I figure out what's interferring.

Mike Franks