FSDreamTeam forum

Products Support => Chicago O'Hare V2 for P3D4 => Topic started by: michaelfairburn on December 23, 2019, 03:47:16 am

Title: Chicago v1 Scenery.cfg error
Post by: michaelfairburn on December 23, 2019, 03:47:16 am
Hi Umberto, I'm getting an error message when I start up P3d (see screenshot attached). When I go to the scenery library to try and delete the area, there is no option either to untick the 'Enable' box or to click on the scenery line and then delete it. Any ideas?  Thanks
Title: Re: Chicago v1 Scenery.cfg error
Post by: virtuali on December 23, 2019, 10:38:21 am
It looks like you removed the V1 O'Hare manually, so you must edit the scenery.cfg manually to remove its area. Or, reinstall O'Hare V1 and uninstall it using the Control Panel.

If you installed O'Hare V2 too, it's best if you do it in this order:

- Uninstall KORD V2

- Uninstall KORD V1

- Reinstall KORD V1

- Uninstall KORD V1

- Reinstall KORD V2
Title: Re: Chicago v1 Scenery.cfg error
Post by: michaelfairburn on December 24, 2019, 01:35:57 am
Thanks for the prompt response Umberto, I'll try that
Title: Re: Chicago v1 Scenery.cfg error
Post by: michaelfairburn on December 24, 2019, 03:12:06 am
Hi Umberto,

I tried what you said and it worked just fine, thank you. I tried to register the KORD v2 serial (xxxxxxxxx), but I get the activation error in the screenshot attached. I have tried deleting and reinstalling the Addon Manager, but still the same. Any ideas? Thanks
Title: Re: Chicago v1 Scenery.cfg error
Post by: michaelfairburn on December 30, 2019, 09:44:43 pm
Hi Umberto, I hope you had a good break over Christmas. This seems to have fixed itself now, so no further help needed, thank you