FSDreamTeam forum

Products Support => Vancouver CYVR support FSX/P3D => Topic started by: bhorv67 on November 15, 2019, 10:05:29 pm

Title: Double taxiway markings & signs / Jetbridges don't line up with Jetways
Post by: bhorv67 on November 15, 2019, 10:05:29 pm
I usually run Live Update each time before I fly and it appeared that I had all latest files. I hadn't flown into CYVR for a while, but when I did today, I noticed there are double taxiway lines & signs, and a lot of the jetbridges don't line up with the jetways.

After the flight I ran live update again, to which a lot of files were updated for CYVR, I'll check again and see if what was updated fixed the issue.
Title: Re: Double taxiway markings & signs / Jetbridges don't line up with Jetways
Post by: bhorv67 on November 18, 2019, 02:26:35 pm
I believe I have resolved this issue by raising the library priority.

Title: Re: Double taxiway markings & signs / Jetbridges don't line up with Jetways
Post by: Dave_YVR on November 18, 2019, 10:39:53 pm
 If you use ORBX, be sure have your library insertion points set correctly. Common for people not set them at all and then have layering issues throughout their sim. Once it's set, you shouldn't have to mess with layers again.