FSDreamTeam forum
Products Support => Vancouver CYVR support FSX/P3D => Topic started by: rullf_1985 on October 05, 2019, 09:44:05 pm
-
Hi there, I have this problem when installing CYVR. The installer starts just fine but when it start installing the textures, I get a window with the title "Setup" window no text and just a OK button. I click OK but the window keeps showing up every time it tries to install a texture.
If a continue with the installation, pressing OK everytime; the end result is no runway/apron textures (black)
https://imgur.com/fjWWini
-
Have you clicked on all the texture selection options ?
-
Yes
-
Could you please indicate exactly which options you chose ?
-
I tried all high textures, 4 seasons.. no joy
medium textures, 2 seasons..no joy
as just requested... low textures, single season... no joy
when it gets to the second part of the installer it just stops, a new window appears with no text on it, only a "OK". The progress bar on the installer turns red. It does that for every texture it tries to generate.
-
I'm sorry, but I cannot reproduce your problem, and nobody else has reported it. Try to disable the antivirus while installing.
-
My apologies for late respond. Work got in the way.
Good news, I got to install. The long story short it was a problem with Direct3D within DirectX. Had to un-install and remove the display drivers and re-install them again. I just re-run the CYVR installer and installed successfully. I am deeply sorry for any inconvenience this cause.
-
Good news, I got to install. The long story short it was a problem with Direct3D within DirectX.
Ok, that's understandable, the installer use a freeware utility to create textures on the fly based on your options, and that one likely requires DirectX to be properly installed.