FSDreamTeam forum
Products Support => GSX Support FSX/P3D => Topic started by: Ray Proudfoot on August 13, 2017, 02:33:01 pm
-
Hi Umberto,
I'm parked at Mega Airport Rome (LIRF) gate 707 in Concorde at 13:25UT. I requested a catering vehicle after the pax were deboarded and a short time later got this message. Any ideas? I did change the GSX gate from Marshaller to SafeDock. P3D v3.4.
couatl v3.2 (build 3829)
panic log started on Sun Aug 13 13:28:31 2017
problem raised by addon <unknown>
Traceback (most recent call last):
File "couatl\common\fsm.py", line 73, in executeDoFuncToCompletion
File "couatl\GSX\assistanceServices\catering.py", line 198, in do
File "couatl\GSX\assistanceServices\baseAssistanceVehicle.py", line 301, in do
File "couatl\common\simObjectMoverIK.py", line 410, in run
MemoryError
{'Airport': 'LIRF', 'Requested assistance services at': 'Gate 707', 'Requested parking services to': 'Gate 707', 'User Pos': (41.79673866695142, 12.24098527425979, 8.09225 m, 3.82525 m, 159.37785142896476)}
-
The error seems to indicate there's a problem with the scenery AFCAD, like orphaned nodes, overlapping nodes or something like that, so GSX couldn't calculate a path for the vehicle correctly.
I'm sure if you run the scenery AFCAD through the ADE "Fault finder" menu, you'll find several issues with it, which would be best to be reported to the scenery developers.
-
The error seems to indicate there's a problem with the scenery AFCAD, like orphaned nodes, overlapping nodes or something like that, so GSX couldn't calculate a path for the vehicle correctly.
I'm sure if you run the scenery AFCAD through the ADE "Fault finder" menu, you'll find several issues with it, which would be best to be reported to the scenery developers.
Thanks Umberto. When this is commercial scenery it really annoys me. Clean AFCADs seem to be their lowest priority. I'll report it to Aerosoft after a fault check.
-
Umberto,
I've run the AFCAD through ADE and can't find anything that might cause this problem. I'm attaching it so you can run your expert eye over it.
-
Umberto,
You suggested my crash was because of a possible problem with the AFCAD. I've attached it as I can't see anything wrong with it. If you can please advise. Otherwise, what is the problem?
-
I still haven't looked at it. I'm on vacation until August 22th so, please excuse a slower response time than usual.
-
Understood, thanks. Enjoy the rest of your holiday. ;)