FSDreamTeam forum
Products Support => Memphis KMEM Support FSX/P3D => Topic started by: tosco92 on June 03, 2016, 09:26:31 pm
-
why in KMEM???
-
If you're running FTX Vector, disable MEM under the AEC tab.
-
If you're running FTX Vector, disable MEM under the AEC tab.
Thank you Bruce. The last three airports I have installed (T2G KSEA, ORBX YMML and FSDT KMEM demo, will buy shortly) have all had this issue. Even disabling Vector in the scenery library made no difference. Now backing up or turning off these 3 airports in the AEC directory of Vector worked. Been driving me crazy for weeks.
Very happy.
Brian
-
If you're running FTX Vector, disable MEM under the AEC tab.
Thank you Bruce. The last three airports I have installed (T2G KSEA, ORBX YMML and FSDT KMEM demo, will buy shortly) have all had this issue. Even disabling Vector in the scenery library made no difference. Now backing up or turning off these 3 airports in the AEC directory of Vector worked. Been driving me crazy for weeks.
Very happy.
Brian
how?
-
If you're running FTX Vector, disable MEM under the AEC tab.
Thank you Bruce. The last three airports I have installed (T2G KSEA, ORBX YMML and FSDT KMEM demo, will buy shortly) have all had this issue. Even disabling Vector in the scenery library made no difference. Now backing up or turning off these 3 airports in the AEC directory of Vector worked. Been driving me crazy for weeks.
Very happy.
Brian
how?
Well, I am assuming you have ORBX FTX_Vector installed in your sim. Go to the Orbx directory in your sim in windows explorer. It should read, e.g. Lockheed Martin/Prepar3D/ORBX/FTX_Vector/FTX_Vector_AEC. Find the file that says KMEM.bgl within the AEC directory. Rename the KMEM.bgl to KMEM.off or KMEM.bac Restart the sim and your FSDT airport should look as it should.
-
It's a lot simpler to use the Vector interface, run the auto configurator to pick up most airports likely to cause issues at one time.
-
I was having the same problem, and ran the Auto-Configuration utility in FTX. It moved both KMEM and KDFW to the disabled column. And that fixed the elevation problem.
However, I also run Aivlasoft EFB, and upon starting it, it said it couldn't find the BGL file for KMEM. Part of EFB shows the airport layout, including all runways, taxiways and gates/ramps. The airport is still on the EFB list, but won't load.
Any ideas on how I can fix this without dumping FTX Global?
-
Have you tried rebuilding the scenery database in AivlaSoft EFB, after altering the Scenery Database with ORBX Vector?
-
Have you tried rebuilding the scenery database in AivlaSoft EFB, after altering the Scenery Database with ORBX Vector?
That did it, Anders. I was unaware of that option until you suggested it. Everything is now working fine again, and I will remember that little "trick" next time. Thanks!