FSDreamTeam forum
Products Support => Geneva FSX/P3D => Topic started by: iPetroSS on May 31, 2015, 09:46:56 pm
-
Hello guys,
took the liberty of moving to P3D 2.5, however I noticed something really really bad in FSDT-Geneva.
The ground polygon of the airport seems cracked and broken in a quite big area.
I did a successful installation of FSDT-Geneva and Addon Manager.
The dll.xml and exe.xml seem to be fine.
Is there a fix for this? Anyone else having the same problem?
I really miss the good old geneva airport I had in fsx.
Thank you.
Peter
-
The Addon Manager doesn't have anything to do with the terrain, and if you have a problem with it, you wouldn't see any scenery.
The problem is caused by another scenery mesh in the area, which has set a different ground altitude so, you must check for every 3rd party mesh scenery that might have an effect, and see if the problem goes away by disabling it.
-
Hi virtuali,
thanks for the reply.
However, I haven't installed any mesh scenery so far.
The closest payware airport I have to Geneva, is Vienna by FT.
I guess I am the only one having this issue? I don't see anyone else mentioning anything similar.
-
I am delighted to say that the issue is solved!
The P3D V2 folder was read-only, so I changed that first.
After that, I run the installer again with administrator privileges and the scenery is fine now.
Anyone having the same issue, could refer to this thread.