FSDreamTeam forum

Products Support => JFK for FSX/P3D => Topic started by: bjratchf on December 06, 2012, 10:15:08 pm

Title: Texture Bleedthrough with Megascenery New York
Post by: bjratchf on December 06, 2012, 10:15:08 pm

I've noticed that the taxiway centerline and signs disappear when taxiing along Papa just abeam the delta terminal. When I go into slew mode, and look down from above, you can see the taxiway line reappear.

I'm running Megascenery New York underneath the JFK scenery (JFK at the higher priority in the library). Any ideas?

Title: Re: Texture Bleedthrough with Megascenery New York
Post by: virtuali on December 07, 2012, 09:06:29 pm

Try with different Mesh density settings. We usually found 10 meters resolution and 100% complexity is ok for most uses.

And, of course, try with the Megascenery turned off. That scenery has just been released, while JFK is out since 2008, I guess if there compatibility problems, it would be their duty and their best interest too (considering that *everybody* has JFK...) be sure that scenery is compatible with our own.