FSDreamTeam forum
Products Support => GSX Support FSX/P3D => Topic started by: BrzI on September 17, 2012, 05:46:52 am
-
Trying to add cargo door loaders but software reports "no cargo doors defined".
How can I force this ?
Thanks
-
You should use the Airplane editor to add cargo doors.
However, I doubt you'll ever be able to use a Cargo loader on a DC9, since the doors are probably too low for the loader vehicle platform to reach. I don't believe DC9/MD80s supports ULDs too, but I might be mistaken...
-
There shouldn't be any need to alter any settings since GSX automatically detects the doors correctly. The screenshot below shows a Coolsky DC-9 right "out of the box" parked at PHKO (Kona Int'l). Look carefully and you'll even see a set of drive=up stairs at Door 1L. I haven't yet disabled the bus.
(http://i711.photobucket.com/albums/ww112/boilerbill/HawaiianDC-9.jpg)
-
With a drive-up staircase, you need to keep the bus active. Security breach to have passengers running loose on the tarmac. :P
-
Apparently you've never been to Kona Airport, Bruce. It's one of the most unique airports that I've seen. There are no jetways -- passengers walk to/from the boarding stairs. When we were there last summer, Hawaiian used the zig-zag type of ramp shown here...
(http://i711.photobucket.com/albums/ww112/boilerbill/3_kona-airport-2012.jpg)
They are great for disabled people, and everyone seems to appreciate the fact that they are much less steep than usual airstairs.
-
Apparently you've never been to Kona Airport, Bruce. It's one of the most unique airports that I've seen. There are no jetways -- passengers walk to/from the boarding stairs.
Which is why we added an option in GSX to disable the passenger bus at specific gates: just to accomodate unusual case like Kona, were the parking position is so close to the gate, that it wouldn't make sense to use a bus.
-
Apparently you've never been to Kona Airport, Bruce.
Only in the simulator... can't afford to visit the real thing, nice as it might be.