FSDreamTeam forum

Developer's Backdoor => GSX Backdoor => Topic started by: richiebacardi on May 22, 2012, 02:32:23 pm

Title: Cut Engines? But I'm not there yet....
Post by: richiebacardi on May 22, 2012, 02:32:23 pm

Taxi-ing to Gate B5 at TTPP I got told to cut engines just as I came onto the taxiway. I ignored it but as soon as I could see the marshaller, he was signalling to cut engines. Any ideas?

Title: Re: Cut Engines? But I'm not there yet....
Post by: virtuali on May 22, 2012, 02:54:48 pm

It's a default scenery ? Check there are no overlapping parking areas in the AFCAD in that area.

Title: Re: Cut Engines? But I'm not there yet....
Post by: richiebacardi on May 22, 2012, 04:23:34 pm

It's Latin VFR's TTCP. The confusing thing is when I repeated the flight and used the "no just warp me there" parking option, It placed me on the parking spot on the bay.

So I thought it wasn't an AFCAD issue.

How can I check this? Or is there another issue?

Title: Re: Cut Engines? But I'm not there yet....
Post by: virtuali on May 22, 2012, 07:03:23 pm

If the AFCAD has problems, it might have been rejected by GSX and the default one might be used instead, which of course will not match the actual scenery. Check the "Customize parking position", and see which AFCAD is currently active, from the GSX point of view.

Title: Re: Cut Engines? But I'm not there yet....
Post by: richiebacardi on May 23, 2012, 09:03:07 pm

Hello again,

It is using the Latin VFR addon scenery.

Regards
Richie