FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: thelaststand on April 17, 2012, 07:45:03 pm

Title: Ifly 737-800 and exit 2 and 3
Post by: thelaststand on April 17, 2012, 07:45:03 pm

Hallo i just bought this great product but i can not use it. It keeps asking me to open exit 2 and 3. I tried modyfying the gsx.cfg like i saw here in the forum in remove=1 value. Nothing the same again. How can i open exits 2 and 3 actually. Is it possible? I use prepar3D and ifly prepar3d version. I have the latest update from gsx installed. Sorry for the stupid questions from a niewbie. Thanks in advance.

Title: Re: Ifly 737-800 and exit 2 and 3
Post by: maggi5 on April 18, 2012, 09:37:07 am

Here's a link to download the all in one Gauge for the Ifly 737.

So you can open all doors.

I also have the ifly and it works well.

http://library.flight1.net/?did=352

Title: Re: Ifly 737-800 and exit 2 and 3
Post by: thelaststand on April 18, 2012, 10:41:22 am

Thank you so much my friend ;) ;)

Title: Re: Ifly 737-800 and exit 2 and 3
Post by: alexchard on May 12, 2013, 09:34:03 pm

I have tried installing this All In One Doors gauge by following the instructions but I cannot get the gauge to show! Please can anyone help?

Title: Re: Ifly 737-800 and exit 2 and 3
Post by: cowings1588 on August 23, 2014, 07:38:44 am

me too, wish there was how to video showing how to do it.. I followed the instructions but must be missing doing something because it doesn't show up either..

Title: Re: Ifly 737-800 and exit 2 and 3
Post by: unc1rlm on December 26, 2014, 02:54:27 pm

I had the same problem. I used the version 2, don't work. I deleted v2 and used original not updated.  You should have 2 versions in the download. If you have already changed the config file, just put the zip version in the fsx module folder. Go to 2d panel and click on electrical aft button, and you should see the 4 gauges. Only 3 doors open, the maintenance button is for the engine cowling. I can't get the right rear door to open . If anyone reads this, and have figured this out, share :)  Hope this helps. youtube video:

Bob